Blamsoft VK-1 Viking Manual de usuario descargar pdf (Pagina 19)

Programmer

The VP-1 Viking Programmer is an optional unit that can be connected to the VK-1 through its

bottom dock connector. See the installation guide. The Programmer gives access to internal

settings that would normally be fixed values. It allows the PGM settings on the modulation

busses to be set to user programmable settings. It also allows for tweaking of other device

settings in Viking.

Modulation Bus Programming

The Mod Wheel and On busses have PGM settings on their Source, Destination, and Shaping

knobs. When PGM is selected, the Programmer takes control of the routing based on the user’s

selection from a list of choices.

Source

Off – Zero

Constant, -Constant – A steady value

Noise – A noise source

Filt Env – The filter envelope

-Filt Env – Zero minus the filter envelope, or the envelope negated

S - Filt Env – The filter sustain amount minus the filter envelope. This results in a

positive value initially, going to a zero value during the sustain phase,

then back positive

Filt Env - S – The filter envelope minus the filter sustain amount. This results in a

negative value initially, going to a zero value during the sustain phase,

then back negative

Vol Env – The volume envelope

-Volume Env – Zero minus the volume envelope, or the volume negated

S - Vol Env – The volume sustain amount minus the volume envelope. This results in

a positive value initially, going to a zero value during the sustain phase,

then back positive

Vol Env – S – The volume envelope minus the volume sustain amount. This results in

a negative value initially, going to a zero value during the sustain phase,

then back negative

S+H Filt - The Sample and Hold waveform smoothed by a filter

Osc 1 - Oscillator 1

Osc 2 - Oscillator 2

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Sin comentarios

Blamsoft VK-1 Viking Manual de usuario Pagina 19