Blamsoft VK-1 Viking Manual de usuario descargar pdf (Pagina 21)

uses approximate solutions to differential equations in the time domain, sometimes called

circuit or analog modeling. The Nonlinear algorithm requires more CPU horsepower than the

Linear algorithm, but in return simulates real transistor amplifiers which have nonlinear gain. A

non-linear gain can be thought of as a compressor, a slight softening of larger amplitudes with

respect to smaller ones, often called soft clipping. Both models have been carefully tuned to

simulate the frequency response and resonant behavior of an analog transistor ladder filter.

The Drive settings use the nonlinear algorithm to create more distortion than the basic

Nonlinear setting. Drive I, II, and III progressively provide more gain into the filter causing it to

soft clip and add a gritty overdrive to the sound.

Global

The Global section configures other various settings on the synth.

Noise – Choose classic for an old school sound, White for the typical noise, or Pink for another

type of noise commonly used in audio.

Gate – This setting can be used to hold the gate open, which would be like always holding down

a key. Usually, this is set to Keyboard so the envelopes are triggered by the notes.

Keyboard Mode – Various monophonic keyboard settings are available to choose from: Last –

the last key pressed sets the pitch. Lowest – the lowest key pressed sets the pitch, Highest –

the highest key pressed sets the pitch, Single – A key will set the pitch as long as it is held

regardless of other key presses

OSC2 Frequency (Fine) – This button enables precise control over the frequency of Oscillator 2.

OSC3 Frequency (Fine) – This button enables precise control over the frequency of Oscillator 3.

It is easier to control the detuning the oscillators if Fine adjustment is enabled.

Release (On) – This button enables the release phase of the envelopes. Generally, this will be

enabled, but if an abrupt note cutoff is desired, the release can be disabled.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Sin comentarios

Blamsoft VK-1 Viking Manual de usuario Pagina 21