Blamsoft VK-1 Viking Manual de usuario descargar pdf (Pagina 20)

Destination

LFO Rate – LFO Frequency

Resonance – Filter Resonance Amount

Spacing – Filter Spacing

Pan - Output panning

Ext Amt - External input volume level

Osc 1 Amt - Oscillator 1 volume level

Osc 2 Amt - Oscillator 2 volume level

Osc 3 Amt - Oscillator 3 volume level

Noise Amt - Noise volume level

Master Vol - Master volume level

Shaping

Off - Zero

Constant - A steady value

PW - Pitch Wheel

MW - Mod Wheel

Note - MIDI Note

Mod 1 - Mod 1 CV input signal

Mod 2 - Mod 2 CV input signal

MW Bus - The other modulation bus

On Bus - The other modulation bus

All of the other shaping values are simply knob settings with the same name.

Filter Programming

The filter configuration and DSP algorithm can be modified using these settings. The number of

poles sets the steepness of the filter frequency response past the cutoff frequency. Each pole

results in 6 dB per octave slope. Fewer poles results in a brighter less filtered, sound.

1 pole – 6 dB per octave

2 poles – 12 dB per octave

3 poles – 18 dB per octave

4 poles – 24 dB per octave

The Circuit setting chooses between various DSP algorithms, or Bypass. The Linear method uses

a transfer function in the z domain that was derived using frequency domain concepts. This is

the most common form of DSP algorithm and enables fast computation. The Nonlinear method

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Sin comentarios

Blamsoft VK-1 Viking Manual de usuario Pagina 20